Fault code · BMW · MINI

BMW: "The vehicle order could not be read from the vehicle"

You replaced the FEM or BDC on a BMW and ISTA stops with "The vehicle order could not be read from the vehicle. Import of the vehicle order required." Here's why, and how the car is brought back to its factory configuration.

By Harshit Vadgama, automotive engineer · Updated

In short

ISTA shows this message when the module that stores the vehicle order (the car's factory equipment list) has been replaced without the parts replacement procedure. The new FEM or BDC is blank. The fix is to restore the vehicle order, either from the old module or by importing it, and then let ISTA program and code the car.

MessageThe vehicle order could not be read from the vehicle. Import of the vehicle order required.
Seen afterFEM replacement (F-series), BDC replacement (G-series)
CauseReplacement module carries no vehicle-specific data
FixRestore or import the vehicle order, then complete the ISTA measures plan
Remote?Yes, with an ICOM or ENET setup and a charger at the car

What the vehicle order is

The vehicle order (VO, in German Fahrzeugauftrag) is the car's factory equipment list: model, market and every option code. ISTA reads it to decide how each control unit is coded. On F-series cars such as the F30 3 Series it lives in the FEM (front electronic module). On G-series cars the body domain controller (BDC) holds it.

Why ISTA can't read it

A new FEM arrives blank. BMW documented this in a service information bulletin for the F30: if the FEM is replaced without following the parts replacement procedure, the new module has none of the car's data, including the vehicle order, and ISTA can't continue. Without a vehicle order ISTA can't code anything correctly, so lights, comfort functions and other modules can misbehave.

How it's fixed

  1. If the old module still communicates, it's connected again and the parts replacement procedure is run properly, so the data is carried over.
  2. If it doesn't, the vehicle order for your VIN is downloaded and imported into ISTA.
  3. ISTA then completes the measures plan: it programs and codes the control units that need it.
  4. Final test of lights, locking, windows and anything the module controls.

This is a programming job, so the battery has to be on a proper charger the whole time. See why battery voltage matters.

Used FEM or BDC?

A used module brings the previous car's data and immobiliser information with it. That's a different and riskier job than fitting a new one, and depending on the module it may need specialist work before it can run in your car. Ask before buying: send your VIN and the part number of the module you're looking at.

For other BMW jobs see BMW coding and programming.

Frequently asked questions

What does 'import of the vehicle order required' mean?

ISTA can't find the car's factory equipment list in the vehicle, usually because the module that stores it was replaced. The vehicle order has to be restored or imported before coding can continue.

Where is the vehicle order stored on a BMW?

In the FEM on F-series cars such as the F30, and in the BDC on G-series cars.

Can this be fixed remotely?

Yes. With an ICOM or ENET setup, a laptop, a battery charger and internet at the car, the vehicle order can be restored and the car programmed remotely.

Sources