Guide · Remote Diagnostics ·

Lotus Diagnostic 20/20: steering angle sensor calibration

A screen recording of a steering angle sensor (SAS) calibration in Lotus Diagnostic 20/20, with notes on when the calibration is needed and what to have ready.

By Harshit Vadgama, automotive engineer

Watch the calibration

The video shows the calibration in Lotus Diagnostic 20/20, the official Lotus diagnostic software. It is on the autocodeRHV YouTube channel.

When a steering angle sensor needs calibrating

The steering angle sensor tells stability control, power steering and other systems where the wheel is pointing. Its zero position has to match the car's straight-ahead position. Calibration is normally needed after:

  • A wheel alignment or any change to the steering geometry
  • Replacing the steering rack, column, clock spring or the sensor itself
  • Suspension work that changes toe or ride height
  • Battery disconnection or module replacement, if the stability or steering warning light comes on afterwards

What to prepare

  • The car on level ground, wheels straight, steering wheel centred
  • A healthy battery or a charger connected, since modules lose power during a long session
  • A Windows laptop with the diagnostic software and the correct interface
  • Fault codes read and noted before you start

After the calibration

Clear the codes, then check that the stability control and steering warning lights have gone out. A short test drive in a straight line confirms the zero point is right. If the light returns, the cause is usually the sensor, its wiring or an alignment that is still off, not the calibration itself.

Need help with a Lotus or another brand?

Message me with the model and the symptom. I'll tell you honestly whether it can be done remotely, and the free VIN check comes first. More on remote diagnostics.

Frequently asked questions

What is Lotus Diagnostic 20/20?

It is the official diagnostic software for Lotus cars, used to read fault codes, view live data and run procedures such as calibrations.

When do I need to calibrate the steering angle sensor?

After an alignment, steering or suspension work, replacing the sensor or steering parts, or when stability and steering warning lights appear after other repairs.

Can I do it without a dealer?

The procedure needs the official software and a suitable interface. Message me with the car and I'll tell you what is possible.